(1) The voltage of the PIC16F1704 chip needs to be adjusted to 3.3V for programming. Click Read to view the burning information. Click Connect, the MPLAB IPE warning check appears, then click OK.ġ1. Note that the hash board does not need to be powered up at this point.ĩ. PICKit 3.5 programmer is directly connected to the P1 position of the hash board, and the direction on the PICKit 3.5 programmer is aligned with the P1 square hole (as shown in the picture). Make sure that the data serial port of the PICKit 3.5 programmer is properly connected to the computer.Ĩ. Enter the password microchip to enter the advanced settings.Ħ. Click Power→VDD voltage to select 3.3V→check Power target circuit from Tool ✔→click Operate to enter the next interface.ħ. Select the corresponding program, open it and enter the next interface, and then select Setting→advanced mode.ĥ. Click File→Import→Hex to find the program storage disk.Ĥ. Set MPLAB IPE V3.10, as shown in the figure below, select PIC12F1572 as Device, and then click Apply.ģ. First, you need to install the burning driver on your computer: Īfter installation, it will look as the following picture:Ģ.
How to reprogram a PIC chip (taking PIC12F1572 as an example) using PICKit 3.5 programmer?ġ. Different miners require corresponding PIC files, and PICKit 3.5 programmer need to be programmed with a programming tool. If the PIC chip data of a miner's hash board is damaged or lost, the hash board will not work. PICKit 3.5 programmer is used to read and save the PIC chip data of the hash board, and the PIC chip stores the chip and voltage data of the hashboard. This product requires personnel with professional knowledge.
The imported USB interface is used to prevent the USB interface from being loose after being unplugged and plugged for many times the brand new original transparent shell, using high-quality materials, the product is more durable at the request of the majority of customers, the surface of the shell is frosted to reduce the use of fingerprints and scratches. Improve the interface, protect the circuit, and the short circuit will not be broken. The programming voltage is stable and the power supply current is large.ĥ. Using 1812 self-recovery fuse and powerful protection circuit.Ĥ. The firmware is self-recovering, no need to disassemble the shell, no need to flash the program, the firmware is automatically restored in 1 minute.ģ.
It perfectly supports all versions of software MPLAB, MPLABX, offline programming will never crash, and the programming speed is faster.Ģ. Compared to kit3, PIC kit3.5 has a firmware self-recovery function.ġ. It is suitable for programming and programming in various situations, and can also burn hash PIC files. PICkit3.5 In-Circuit Debugger Programmer PICkit3.5 is an online debugger programmer, the official authentic product, and the economy is stable.
0 kommentar(er)
